Previous Article | Next Article ![]()
Journal of Bacteriology, April 2005, p. 2555-2557, Vol. 187, No. 7
0021-9193/05/$08.00+0 doi:10.1128/JB.187.7.2555-2557.2005
Copyright © 2005, American Society for Microbiology. All Rights Reserved.
Division of Molecular and Radiation Biophysics, Petersburg Nuclear Physics Institute, Russian Academy of Sciences, Gatchina/St. Petersburg, Russia
Received 5 November 2004/ Accepted 29 December 2004
|
|
|---|
|
|
|---|
The biochemical and recombination activities of five RadA proteins from different hyperthermophilic crenarchaeons and euryarchaeons have been described (6, 7, 10, 14, 17). One of them, RadA from Pyrobaculum islandicum (RadAPi), has been studied in more detail than the others. The ATPase of its PC exhibits two disparate catalytic modes, and its PC is active within a wide temperature range (from 37 to 90°C) (17).
Earlier, we described a distinguishing property of RadA protein from crenarchaeon Desulfurococcus amylolyticus (RadADa), namely, its ability to promote efficient strand exchange even at 95°C (6). Here, we continued the analysis of biochemical activities of RadADa and presented its additional characteristics, which include both expected and distinguishing properties of the protein with regard to known activities of the RecA and RadA recombinases.
ATP hydrolysis is an intrinsic property of the ternary PC (RecA/RadA/Rad51::ATP::ssDNA) formed by any member of the homologous recombinase family. The hydrolysis rate is strongest for the RecA PC (kcat = 30 min1) and is reduced roughly 10 times for representatives of the RadA/Rad51 subfamily. Though ATP hydrolysis is not necessary for the initiation of recombination by the PC, it is essential for the strand exchange progression and completion (4). Since the accumulation of ADP results in PC inactivation, the ATP hydrolysis is routinely used to monitor an active state of PC.
As ATP hydrolysis catalyzed by RadADa was measured at temperatures around 90°C and above in the absence of ATP-regenerating system, a linear part of ATPase kinetics was observed within the limits of 1 to 4 min of the reaction (data not shown). Unless otherwise specified, the experimental conditions used in all further experiments were as follows. The reaction was carried out at 90°C in the 20-µl mixture containing TMD buffer (25 mM Tris-HCl [pH 7.5], 10 mM MgCl2, and 1 mM dithiothreitol), 20 mM NaCl, 1 mM ATP, 15 µM RadADa, and 150 µM
X174 ssDNA (in nucleotides [nt]). The amount of [14C]ATP hydrolyzed was measured by using a thin-layer chromatography method as described previously (6).
The 20 mM NaCl used in this mixture was found to be optimal for ATP hydrolysis catalyzed by RadADa (kcat = 3.2 min1) (Fig. 1). This concentration is fivefold lower than that used for RadAPi (17). Moreover, the addition of 100 mM NaCl resulted in a 3.2-fold decrease of the monomer kcat value. Similar results were obtained with KCl (data not shown). The data indicate a pronounced sensitivity of the RadADa ATP hydrolysis to monovalent cations.
![]() View larger version (12K): [in a new window] |
FIG. 1. The rate constant for ATP hydrolyzed by the RadADa::ATP::ssDNA PC as a function of NaCl concentration. Optimal experimental conditions (90°C, X174 ssDNA) were used; see the text for details.
|
The effect of ssDNA chain length on kcat is presented in Table 1. Two oligonucleotides (21 and 53 nt), four PCR fragments (from 250 to 940 bp) of human genomic DNA, dsDNA, and ssDNA of two phages were used as DNA cofactors in PC-dependent ATP hydrolysis. Different forms of M13 phage DNA were used to control the complete melting of dsDNA molecules under experimental conditions. Circular and linearized M13 ssDNA demonstrated the same ability to stimulate ATP hydrolysis as a linearized dsDNA of this phage, whereas the supercoiled dsDNA (replicative form I) was a weak cofactor due to the only partial denaturation at 90°C (Table 1). At optimal assay conditions, the RadADa PC was able to hydrolyze ATP efficiently with ssDNA cofactors of 940 nt and greater. This cofactor size is about 30-fold longer than that for RecA protein from Escherichia coli (RecAEc) (2). Thus, RadADa prefers lengthy ssDNA as cofactors for ATPase activity, and the same preference could probably be applied to the formation of the PC.
|
View this table: [in a new window] |
TABLE 1. The rate constant of ATP hydrolysis as a function of ssDNA chain length in composition of the RadADa presynaptic complexa
|
The ability of RadADa PC to promote recombination at 95°C encouraged us to look for the highest temperatures at which the PC can hydrolyze ATP and to determine factors which provide such thermostability. In Fig. 2A, the rate constants of PCs formed at the temperatures indicated (80 to 100°C) are compared with those of PCs formed at 80°C. Results suggest that the preformation of PCs at 80°C guarantees the conservation of at least a part of the activity up to 102°C.
![]() View larger version (16K): [in a new window] |
FIG. 2. Factors of the RadADa PC thermostabilization. (a) ATPase activity as a function of temperature. The PC was formed (circles) or preformed at 80°C (triangles), and its ATPase was measured at the temperatures indicated. (b) The residual ATPase activity as a function of RecADa preliminary temperature preincubation in TMD buffer with 20 mM NaCl for the times indicated. Circles, 15 µM RadADa preincubated at 90°C; triangles, 180 µM RadADa preincubated at 100°C.
|
Figure 3 shows the thermodependence of the RadADa PC ATPase, presented in coordinates of an Arrhenius plot. The graph reveals two catalytic modes of ATPase activity with the transition point at 70°C and may reflect the transition between two conformation states of the protein with different modes of functional activation. The first mode has a relatively high energy of activation (46 kcal/mol), whereas the second one has a much lower activation energy (13.9 kcal/mol). In addition, the protein is characterized by a negligible activity below 65°C. For comparison, the thermodependence of RadAPi is presented in the same coordinates (see the data from Fig. 6 in reference 17). The latter also exhibits a biphasic Arrhenius plot with two characteristic energies of activation and a transition point at 75°C. The difference between thermodependence of the crenarchaeal recombinases RadADa and RadAPi appears obvious. RadAPi belongs to a class of thermotropic proteins which maintain activity in a wide range of temperatures (37 to 90°C), whereas the activity of RadADa is strongly temperature dependent, being close to zero at temperatures below 65°C. Summarizing all data presented in the paper, we suggest that RadADa represents a new class of thermophilic recombinases.
![]() View larger version (16K): [in a new window] |
FIG. 3. The comparison of PC thermodependence for RadADa and RadAPi monitored by their ATPase activities. The solid thick line and the broken line show the Arrhenius plot of RadADa and RadAPi, respectively. Eact (activation energy) was calculated from the formula Eact = RT ln(kcat) for each linear part of the plot. The transition temperatures between two catalytic modes (70 and 75°C) are shown. The data for RadAPi were published earlier (17).
|
This work was partially supported by a Fogarty International Research Collaboration Award (grant 2 R03 TWO1318-04).
|
|
|---|
-helix E as a liaison between the subunit-subunit interface and the DNA and ATP binding domains of RecA protein. Genes Cells 3:79-97.[Abstract]
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2009 by the American Society for Microbiology. For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»